Jun 3, 2006 · First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...

May 4, 2014 · This fixes the problem however, when I push the up/down button, the door goes to fully open then it does two long beeps then two quick chirped, ...

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...

Jan 4, 2014 · I have the iDrive for TorqueMaster. I am the original owner of the house since late 2005. My problem is when the weather gets below 40F the ...

Apr 23, 2012 · My current problem is that I can not get the drive motor free from the shaft. Pulling the release cable does not free the motor. I backed ...

While shutting down the unit beeps several times and then is completly dead. The only way to get it running again is to unplug it for approximatly 1/2 hour.

My idrive torquemaster opens 1 inch, makes a horrible noise (like gears stripping) beeps, then stops. It did this one other time and acted like it didn't have ...

Jan 4, 2009 · Gently tap the aluminum tube while pulling the non broken spring and it will slowly work it way out to where you can grab the white nylon ...