Jun 3, 2006 · It was blown. The customer service explained to me that the fuse it uses is the 250-volt, 4-amp slow-blow fuse (see photo below). It could be ...

My current problem is that I can not get the drive motor free from the shaft. Pulling the release cable does not free the motor. I backed the detent pin all ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Sounds like the spring broke and the door came slamming down. If the spring is still intact, then the things that fastens the spring to the bar is loose. The ...

Aug 24, 2010 · All it does is beep twice at me and when I try and profile it, the iDrive foot moves a fraction of an inch like it's attempting to open the door ...

Mar 5, 2009 · No beeps when hitting the reset button. After checking the owner's manual I figured the fuse is blown. The circuit board has a rectangular ...

Jan 4, 2014 · After heating up the iDrive, it did not hang up once going up or down. I am sure it will hang up in a few hours once the unit cools down ...

Dec 6, 2005 · After losing one of the two torsion-springs. The door is no longer counter-balanced and is very heavy. Of course the idrive garage opener can't ...

Use the programming instructions provided with your vehicle first. Follow these instructions if the HomeLink™ unit does not learn the transmitter, by using the ...

Wayne Dalton idrive Troubleshooting Tip #2 - Check the Motor Guide Position. Thu, 05 Sep 2013 19:06:39 -0700. I-drive motor not engaging. Sun, 25 Aug 2013 22 ...