Jun 3, 2006 · A fuse is on the top left hand corner of the circuit board. It was blown. The customer service explained to me that the fuse it uses is the 250- ...

I took the idrive down (with the torsion bar), removed the motor and circuit board, and rapped the right angle support bracket several times with a dead blow ...

Mar 5, 2009 · No beeps when hitting the reset button. After checking the owner's manual I figured the fuse is blown. The circuit board has a rectangular ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Jan 4, 2014 · Today (1/4/2014) it is about 20F. I took a heat gun (on the low setting) to the unit to warm it up to about 80F. After heating up the iDrive, it ...

Dec 6, 2005 · The door is no longer counter-balanced and is very heavy. Of course the idrive garage opener can't open an unbalanced door. Did idrive cause the ...

May 4, 2014 · Lately, the door opens fine but when it closes, it comes down to about 5' from the floor then it stops and reverse to full open. Follow the ...

Sep 12, 2009 · With the motor in the up position and manual release cable pulled, the torque tube does not turn freely in the Idrive. It is hard to turn and ...

The solution was to re-lub the motor shaft, There are two hex screws that hold the motor and found on top of the motor. Easy to get to with the motor pivoted ...

Programming. Training HomeLink™ Unit. 1. Pull the Manual Disconnect to put the operator in the disengaged position. 2. Verify the HomeLink™ unit has an ...