When I push the remote button, my torsion drive unit beeps 5 times and the garage light flashes on and off. The door doesn't move. I read elsewhere this means ...

Jun 3, 2006 · While 2 beeps does indicate a calibration/install problem, it doesn't necessarily mean you just need to run calibration. My unit started having ...

Dec 6, 2005 · It said that if the "door stops or reverses, and the opener beeps three or four times," then any of the following three is the problem: " ...

May 4, 2014 · Lately, the door opens fine but when it closes, it comes down to about 5' from the floor then it stops and reverse to full open. Follow the ...

Nov 24, 2023 · Instead, it beeped four times. Based on the "Troubleshooting" section of the instruction manual, there are three possibilities: Obstruction ...

Sep 17, 2011 · However, if you press the profile button for five seconds, but the idrive beeps twice and doesn't attempt to open/close the door, then the ...

Apr 23, 2012 · I took the idrive down (with the torsion bar), removed the motor and circuit board, and rapped the right angle support bracket several times ...

Jun 26, 2007 · It got stuck a few times in the past week. I pull the quick-release handle and played with the door a bit. It's obvious that it's bottom ...

Jul 16, 2008 · Door does not move and the Opener beeps two times. The install routine has not been performed. Perform the install routine Steps 32 and 33 ...

On my I-drive, about every six months now, the operator starts having problems, I pull down the motor, lube it up and in an instance it back to normal. No ...