Dec 6, 2005 · To run the install routine, press and hold the profile button (only on the Wall Station remote). The idrive opener will open the door fully and ...

Jun 26, 2007 · It got stuck a few times in the past week. I pull the quick-release handle and played with the door a bit. It's obvious that it's bottom heavy.

Jun 3, 2006 · My advise to all is if you are having problems - first manually cycle your door to make sure it is in balance and has no friction spots. The ...

Jan 4, 2009 · My problem is that my door will not open. On the right hand side where the wire coils up..inside that, the plastic part that tighen to the ...

The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor. I ran it ...

Apr 16, 2015 · With the door fully closed, if you hit the button to lift the door, the motor turns, the door does not move, and there is a mechanical grinding/ ...

Sun, 22 Feb 2015 13:59:06 -0800. Remote Problems with idrive for Torsion Springs ; Thu, 19 Feb 2015 20:17:08 -0800. idrive opens garage door 6 inches at a time.

When you open a well-balanced garage door manually, all you do is use the torsion bar, springs, and cables to lift the door for you. That's what the iDrive does ...

[MOVED] Wayne Dalton idrive for Torsion Springs - Pitfall #1: Garage Door Will Open. This thread has been moved to the Wayne Dalton forum.

During programming the garage door may operate. Pull the Manual Disconnect to put the operator in the disengaged position (see Step 1 below). Make sure people ...