Jun 3, 2006 · I've had my iDrive for 6+ years now and it stopped today. It was 2 beeps (or beep buzz beep buzz) which is usually fixed by hitting the profile ...

idrive will not close. I tried to run the profile routine but it opens then tries to close then stops. ... Does not move is the 1/4, 1/2, and 3/4 open position.

Nov 24, 2023 · Wayne Dalton idrive for Torsion Springs - Solution #1: Install Custom Upper Limit to Successfully Profile.

Apr 16, 2015 · To check some other frequent problems, I THINK the door is balanced fine, it does not seem to be a fuse, the position sensor is in the ...

Aug 24, 2010 · All it does is beep twice at me and when I try and profile it, the iDrive foot moves a fraction of an inch like it's attempting to open the door ...

Programming. Training HomeLink™ Unit. 1. Pull the Manual Disconnect to put the operator in the disengaged position. 2. Verify the HomeLink™ unit has an ...

Apr 23, 2012 · The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the ...

Feb 22, 2010 · I moved into a house which has an iDrive for torsion springs installed. It worked fine for about 5 months, but about 3 weeks ago when I came ...

Dec 6, 2005 · Maybe it had lost the up and down positions. To run the install routine, press and hold the profile button (only on the Wall Station remote).

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...