Problem After Changing Spring
I put a new single spring in my i-drive Opener tube (right side wind) After winding it 16 turns, I manually try to lift the door. It goes up about 18 inches and then if I lift it higher, the cables have slack. I've redone the installation several times and every time I can only lift to the same height. I even tightened the spring a bit more and it keeps going only to the same height.
I have the exact same issue. I can manual open my door to about 3/4 open and the the cable becomes slack on the drums.
Did your message disappear? Read the Forums FAQ.
Spam Control | * indicates required field
TrackBack only accepted from WebSite-X Suite web sites. Do not submit TrackBacks from other sites.
No TrackBacks yet. TrackBack can be used to link this thread to your weblog, or link your weblog to this thread. In addition, TrackBack can be used as a form of remote commenting. Rather than posting the comment directly on this thread, you can posts it on your own weblog. Then have your weblog sends a TrackBack ping to the TrackBack URL, so that your post would show up here.
Messages, files, and images copyright by respective owners.
107 Users Online
Copyright © 2004 - 2020. All Rights Reserved.