Jun 3, 2006 · My advise to all is if you are having problems - first manually cycle your door to make sure it is in balance and has no friction spots. The ...

Nov 24, 2023 · Seeing the motion, I am guessing the idrive is either having a hard time starting the motion when the door is on top or it feels the obstruction ...

Apr 16, 2015 · With the door fully closed, if you hit the button to lift the door, the motor turns, the door does not move, and there is a mechanical grinding/ ...

Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle ...

When you open a well-balanced garage door manually, all you do is use the torsion bar, springs, and cables to lift the door for you. That's what the iDrive does ...

Jun 26, 2007 · It got stuck a few times in the past week. I pull the quick-release handle and played with the door a bit. It's obvious that it's bottom heavy.

Apr 23, 2012 · The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor ...

Jan 4, 2014 · 2 or 3 years ago I had garage door technicians in the try and adjust the unit so it would not be temperature sensitive. They lubricated ...

During programming the garage door may operate. Pull the Manual Disconnect to put the operator in the disengaged position (see Step 1 below). Make sure people ...

Jul 16, 2008 · The torsion idrive® opener will only work on sectional doors. Do not install on one piece doors. Your garage door must be properly balanced ( ...