Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Apr 23, 2012 · Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive ...

Jun 3, 2006 · First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...

Jan 4, 2014 · I have the iDrive for TorqueMaster. I am the original owner of the house since late 2005. My problem is when the weather gets below 40F the ...

Tue, 27 Jan 2015 15:06:43 -0800. Wayne Dalton idrive Torquemaster model 3661 Closes Half-Way ; Tue, 13 Jan 2015 10:42:24 -0800. no tension in the cables ; Tue, 30 ...

Jan 4, 2009 · The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...

Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...

Press the HomeLink™ button once more to operate the door. idrive™ garage door openers with YELLOW antenna wires are compatible with all HomeLink™ units.

Wayne Dalton has done a fabulous job on making on the adjustments needed. It is by far the best residential opener on the market. The complaints you here are ...