Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Jun 3, 2006 · First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...

Jan 4, 2014 · I have the iDrive for TorqueMaster. I am the original owner of the house since late 2005. My problem is when the weather gets below 40F the ...

Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive independently from ...

Mar 5, 2009 · When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...

Wayne Dalton has done a fabulous job on making on the adjustments needed. It is by far the best residential opener on the market. The complaints you here are ...

Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...

Jan 4, 2009 · The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...

Jun 26, 2007 · Torsion springs are an item that get slightly weaker over time. I suggest you reprofile your idrive every couple of months so it always is ...

My idrive torquemaster opens 1 inch, makes a horrible noise (like gears stripping) beeps, then stops. It did this one other time and acted like it didn't have ...