Removing Dethreaded Nut. While torquing down the top locking nut on my damper, I de-threaded it (even though I was using a torque wrench).

The easiest way to pop this plastic top off is with a mini hacksaw and a flat-head screwdriver. The photo below shows an example of a mini hacksaw. The saw ...

Jun 1, 2013 · But watching the following video showed me the trick. The trick is basically spray silicone lubricant onto the rubber bushing, where it touches ...

Pealing off the aluminum cover, you'll uncover four screws. Unscrew these screws and remove the black plastic cover. Then locate the two small screws under the ...

Jan 15, 2006 · Simply take a standard T-20 torx bit and carefully grind all but one of the 6 "flukes" away. The remaining fluke will align in any notch and ...

This past week, I've been wrestling with the top locking nut on the Eibach Pro-Damper for my 1995 Honda Civic EX Coupe. The nut was stripped and I managed to ...

And the mechanic found that the axle nut on the wheel was loose. He tightened it and the noise went away. It's amazing that something so simple is so hard ...

Jan 4, 2009 · The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...

I have a laptop computer with a built-in memory card reader. I have a dedicated ReadyBoost 32 GB microSD card in the slot. I noticed that Windows 10 boots up a ...

You'll need to unscrew the four screw shown in the photo below. </p> <center> ... removing the screws, the hard drive can be detached from the USB circuit ...