Jan 4, 2009 · I had the same problem. The directions from Wayne Dalton were spot on. Gently tap the aluminum tube while pulling the non broken spring and it ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Today 12-7-09 the door just started only going up about 8 inches and stops It labors very hard to raise it the 8 inches. When I push the button again it slams ...

Dec 6, 2005 · The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...

Jun 3, 2006 · My advise to all is if you are having problems - first manually cycle your door to make sure it is in balance and has no friction spots. The  ...

I have everything hooked up correctly and I can't get the door to lift any easier. (torquemaster plus). bobby. Sun, 22 Nov 2009 19:01:12 +0000. Add Comment ...

Apr 23, 2012 · The door is in the closed position, the motor is down, but still locked to the torsion bar. Pulling the release cable does not release the motor ...

Jul 1, 2009 · If your spring is working at all, chances are it is not broken. Before you purchase new springs, closely check the spindle that the cable winds ...

I had a Idrive Torsion Spring and every time it closed it slam the door down to the floor very hard. ... Is it an insulated garage door? Is the garage door ...

Mar 5, 2009 · After the snow storm that recently hit our area one of our idrive doors became frozen stuck. When I tried to open it it hummed for a few seconds ...