Jan 4, 2009 · The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

Dec 6, 2005 · After losing one of the two torsion-springs. ... They should be lubricated every few months with silicone spray. ... problem: "Obstruction ...

Jun 3, 2006 · This started happening, I thought, after the door closed on top of an air hose and apparently jammed it.

Jul 1, 2009 · If your spring is working at all, chances are it is not broken. Before you purchase new springs, closely check the spindle that the cable winds ...

Fixing the Torsion Springs on Wayne Dalton Torque Master ... idrive TorqueMaster only goes up after thunder storm ... Wayne Dalton 9600 with Torque Master Plus ...

Jan 4, 2014 · Today (1/4/2014) it is about 20F. I took a heat gun (on the low setting) to the unit to warm it up to about 80F. After heating up the iDrive, it ...

Jun 26, 2007 · Torsion springs are an item that get slightly weaker over time. I suggest you reprofile your idrive every couple of months so it always is ...

Sep 12, 2009 · With the motor in the up position and manual release cable pulled, the torque tube does not turn freely in the Idrive. It is hard to turn ...

Last week my Wayne Dalton door torque tube spring broke. The anchor bracket tore completely off the garage door & the damaged the garage door even breaking the ...