Google
×
Jun 3, 2006 ˇ First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...
Jan 4, 2014 ˇ Today (1/4/2014) it is about 20F. I took a heat gun (on the low setting) to the unit to warm it up to about 80F. After heating up the iDrive, it ...
For assistance with your I-Drive garage door opener, please contact Wayne-Dalton Garage Door Opener Support Center at 888-827-3667. Wayne-Dalton Support Center.
Apr 16, 2015 ˇ With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...
Mar 5, 2009 ˇ When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...
Jan 4, 2009 ˇ The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...
Tue, 27 Jan 2015 15:06:43 -0800. Wayne Dalton idrive Torquemaster model 3661 Closes Half-Way ; Tue, 13 Jan 2015 10:42:24 -0800. no tension in the cables ; Tue, 30 ...
Dec 6, 2005 ˇ The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...
Continue holding the HomeLink™ but- ton, and press and hold the desired button on the Wayne-Dalton transmitter for approximately 3-5 seconds. The HomeLink™ LED ...
Apr 23, 2012 ˇ Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive ...