Jun 3, 2006 · Recently, my garage door became off-balance. Whether it's due to the earth shifting or the old cable drum about to fail is still being ...

Apr 23, 2012 · My current problem is that I can not get the drive motor free from the shaft. Pulling the release cable does not free the motor. I backed the ...

Dec 6, 2005 · After losing one of the two torsion-springs. The door is no longer counter-balanced and is very heavy. Of course the idrive garage opener can't ...

Nov 24, 2023 · Seeing the motion, I am guessing the idrive is either having a hard time starting the motion when the door is on top or it feels the obstruction ...

Apr 16, 2015 · With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...

It took me a couple of hours to make room for the spring brackets without damaging or weakening the bottom cable brackets. After I finish the installation and ...

Jun 26, 2007 · Now the same symptom showed up again. Being an engineer, it's obvious to me that there is nothing wrong with the door, the springs, nor the ...

Mar 5, 2009 · No beeps when hitting the reset button. After checking the owner's manual I figured the fuse is blown. The circuit board has a rectangular ...

During programming the garage door may operate. Pull the Manual Disconnect to put the operator in the disengaged position (see Step 1 below). Make sure.

Jul 16, 2008 · If the door drops fast going down, the door may need spring tension increased. If the door operates properly, then proceed to your idrive® ...