Google
×
Apr 16, 2015 ˇ With the door down, if you push the button to raise it, the motor runs and makes a nasty grinding sound. The door does not move. If you pull the ...
While shutting down the unit beeps several times and then is completly dead. The only way to get it running again is to unplug it for approximatly 1/2 hour.
Jun 3, 2006 ˇ First check to make sure it's not a tripped circuit in your circuit box. If it does come down to the idrive, I suspect that the fuse in the ...
Apr 23, 2012 ˇ Just loosen the two gears, on both sides of the idrive, that are attached to the torsion bar from the idrive. Then you can rotate the idrive ...
Jan 4, 2014 ˇ I have the iDrive for TorqueMaster. I am the original owner of the house since late 2005. My problem is when the weather gets below 40F the ...
Jan 4, 2009 ˇ The culprit in this spring removal problem is the nylon tube that gets "glued" to the inside walls of the shaft. I used a small diameter steel ...
Mar 5, 2009 ˇ When I tried to open it it hummed for a few seconds then quit. No beeps when hitting the reset button. After checking the owner's manual I ...
Programming. Training HomeLink™ Unit. 1. Pull the Manual Disconnect to put the operator in the disengaged position. 2. Verify the HomeLink™ unit has an ...
Dec 6, 2005 ˇ The idrive opener will open the door fully and stop. Then it will close the door completely. Finally, it will perform the up and down cycle one ...
Jun 1, 2006 ˇ These are good openers and have a place in the market. They really only have 3 main parts. Motor, circuit board, and limits. Not much to break.